No products in the cart.
Roll over image to zoom in
MP-8X20-12-2: The Ultimate Compliance Solution for Your Business
$7,236.00
Compliance West MP-8X20-12-2: The industry’s only 8-port, 20-amp, 12-circuit power strip with a built-in surge protector, providing unparalleled power distribution and protection for critical equipment.
The MegaPulse 1.250-12±2 ohm is our 12kV, 6kA combination tester, with a 30 second cycle time. It can produce a combination test waveform at 2 ohms from 500V to 12kV, in tolerance with EN 60060.
For example, the MegaPulse 1.250/820-12±2 ohm Surge Tester is specifically designed to perform the Impulse Test on transient overvoltage limiting devices in accordance with EN 61010, Para. 14.9, Table 17 and Table 18. This tester can perform all the tests shown in Table 17 at either 2 or 12 ohms as shown in Table 18. The output is in accordance with the published waveform from 500-12000V peak (open and short circuit). The tests can be done with a 30 second or longer wait between pulses, well within the Standard requirement of 1 minute or less. A 12 ohm tap is provided for testing Category II devices in accordance with Table 18, in accordance with the Standard. The 12 ohm tap will be in accordance with the tolerances of the voltage waveform only, as allowed by the Standard.
The MegaPulse 1.250/820-12±2 ohm is equipped with a relay allowing switch selected polarity output. With the switch selected polarity output, users may opt for computer control via our option TestMinder MegaPulse, or PLC guided operation with our Relay Isolated Control board. Some users may not need this level of automation in their testing, and we can accomodate them with our model MegaPulse 1.250/820-12 2 ohm. Polarity is changed by manually switching leads.
Pos/neg polarity, grounded output, 500V min, 12 ohm tap, not for use with CDN. 30 sec duty cycle, <,30 sec. charge time.
- Outputs a combination waveform at 500 12kV, 2 ohms.
- Front panel switch allows waveform reversal (±2 ohm model only).
- 30 second pulse repeat rate.
- 12 ohm tap provided, in accordance with EN60060 (voltage waveform only).
- Can be controlled from PLC or LabView with Option RI (±2 ohm model only).
- Outputs up to 12000V peak.
- Virtual Impedance of 2/12 ohms.
- Available TestMinder for computer control of long test sequences (±2 ohm model only).
- Provided with NIST calibration good for one year, A2LA/17025 calibration available.
- 1 year warranty.
